Page Comparison

Step 1 - Describe databases
========================================
The first step is to describe databases used in the replication. There are usually 
two of them (source and target); however, there can be just one (when
source and target is the same) or more than two (one-to-many or other complex 
configurations.)  
Following databases are now configured:
1: Oracle orcl, SYS/**, SYSTEM/*, dbvrep/**, USERS/TEMP, dbvrep/, ASM:YES,TZ: +00:00 
2: Oracle test11202, SYS/**, SYSTEM/*, dbvrep/**, USERS/TEMP, dbvrep/, ASM:NO,TZ: +00:00 
3: Oracle dbvisit210_d112f, SYS/**, SYSTEM/*, dbvrep/**, USERS/TEMP, dbvrep/,  ASM:NO,TZ: +00:00 
Enter number of database to modify it, or "add", or "done": [done]

Step 2 - Replication pairs
========================================
The second step is to set source and targets for each replication pair. This is 
usually just choosing the first database as source and the second one as
target, but many more configurations are possible. 
Following replication pairs are now configured:
Following replication pairs are now configured:
1: orcl (Oracle) ==> test11202 (Oracle), DDL: yes, fetcher: no, process suffix: (no  suffix), compression: no, encryption: no, network: LAN timeout: 60, prepare type: single-scn, data load: dp_networklink

2: orcl (Oracle) ==> dbvisit210_d112f (Oracle), DDL: yes, fetcher: no, process suffix: (no suffix), compression: no, encryption: 1no, network timeout: 60, prepare type: LAN single-scn, data load: dp_networklink
Enter number of replication pair to modify it, or "add", or "done": [done]