...
4. Ensure the network connection is correct.
| Note |
|---|
If the System Readiness check fails then please see below for a guide to troubleshooting these issues |
5.Dbvisit Standby is now installed and must be configured for a specific database.
...
Shortcuts will have been created for Dbvisit Standby under Programs > Dbvisit > Standby.
The shortcuts are:
The Dbvisit Standby command console is the main utility to execute Dbvisit Standby commands for CLI.
Shortcuts have also been created for Bitvise Tunnelier and Bitvise WinSSHD. For more information about Bitvise WinSSHD and Tunnelier please visit http://www.bitvise.com
Run as Administrator
In order to execute the dbvisit standby commands successfully it is required to run them as administrator. Following steps need to be performed to make sure it runs as administrator privilege to avoid any privilege related errors.
1. Go to properties of 'Dbvisit Standby Setup' and select Compatibility tab.
2. Click on 'Change settings for all users'.
3. In privilege section click on 'Run this program as an administrator' checkbox.
4. Click Apply.
5. Go to properties of 'Dbvisit Standby command console' and select Shortcut tab'.
6. Click on 'Advanced...'.
7. Click on 'Run as administrator' checkbox.
8.Click OK and Apply.